< Previous | Contents | Next >

Programming an empty control unit

When a new engine control unit is installed, where no software has been downloaded, the control unit must be programmed.

The new control unit must have the same part number as the old control unit. If the control units do not have the same part number, it will not be possible to program the new control unit until a “Conversion kit” has been ordered from Volvo Penta.

If the control units have the same part number, the new control unit can be programmed as usual. Please refer to Reprogramming a control unit page 54.

If the part numbers do not coincide – proceed as pos- sible:

1 Have both part numbers available.

image

2 Log in to Volvo Penta Partner Network’s web site:

www.vppn.com

3 Choose “Service & Warranty > VODIA > Conver- sion kit / Accessory kit wizard”.

4 Select engine type and function.

5 Select conversion kit(s) and chassis ID.

6 All selections will be shown in a summary. Click continue if they are correct.

7 Volvo Penta’s database is now updated. It can take about a minute before a confirmation is sent.

8 Programming of the control unit can now start.

Please refer to Reprogramming a control unit page 54.



image

P0008397


دیزل ژنراتور | ماشین های راهسازی | لودر | بیل مکانیکی | لیفتراک | موتور پمپ | پمپ آب