< Previous | Contents | Next >
Check of sensor, fuel pressure
1. Turn off engine
2. Disconnect the oil pressure sensor connector block and connect the 7-pin adapter 9998567 be- tween the oil pressure sensor’s connector unit and the engine cable harness. Then connect the multi- meter 9510060 between measurement points 1–4.
3. Turn on the control voltage.
4. Measure with the multimeter set to voltage mea- surement. Check that the multimeter shows 5.0 volt.
5. Now connect the multimeter between measure- ment points 2 – 4.Voltage should be about 0.5 V at normal atmospheric pressure.