< Previous | Contents | Next >

Check of sensor, crankcase pressure


image image


1. Turn off engine

2. Disconnect the charge air pressure sensor con- nector block and connect the 4-pin adapter 9998534 between the charge air pressure sensor’s connector block and the engine cable harness. Then connect the multimeter 9510060 between measurement points 1–4.

3. Turn on the control voltage.

4. Measure with the multimeter set to voltage mea- surement. Check that the multimeter shows 5.0 volt.

5. Then connect the multimeter between measure- ment points 2 –4. Voltage should be about 3 V at normal atmospheric pressure.


temperature


دیزل ژنراتور | ماشین های راهسازی | لودر | بیل مکانیکی | لیفتراک | موتور پمپ | پمپ آب