< Previous | Contents | Next >

Functional check of relay

Multimeter 9510060 is used during the fault tracing procedure.

Two different symbols visualize conductor status. Symbol 1 indicates open circuit or very high resis- tance (~). The multimeter does not sound.

Symbol 2 indicates connection or very low resistance. The multimeter sounds.

Perform a functional check of the relay as follows:


image

NOTE: Remove the main relay from the engine before fault tracing.

1. Use the multimeter set to buzzer signal. Measure between relay pins 87a and 30. The multimeter should sound.

image

2. Use the multimeter set to buzzer signal. Measure between relay pins 87a and 30. The multimeter should sound.

3. Use the multimeter set to resistance measure- ment. Measure between relay pins 85 and 86. The multimeter should show 240–270 Ω.

image

4. Connect 24V between pins 85 and 86. Use the multimeter set to buzzer signal. Measure between relay pins 87 and 30. The multimeter should sound.

5. Connect 24V between pins 85 and 86. Use the multimeter set to buzzer signal. Measure between relay pins 87a and 30. The multimeter should not sound.

6 Replace the relay if the above test is not complet- ed satisfactorily.


image



image



دیزل ژنراتور | ماشین های راهسازی | لودر | بیل مکانیکی | لیفتراک | موتور پمپ | پمپ آب